Avaya Communication Manager Administrator's Manual page 1197

Far End Test Line No.
Specifies the number sent to the far-end's ISDN test line extension. When the test trunk
long command is issued, this exact number is sent to the far-end to establish a call that tests
the integrity of the trunk member under test. The number does not pass through routing or
undergo digit manipulation. The digits entered must be what the far-end expects. For example,
for an ISDN tandem trunk, the far-end test number should be a 7-digit ETN (Electronic Tandem
Network) number.
Valid entries
Up to 15 digits
blank
Incoming Calling Number Insert
Valid entries
Enter up to 15 characters
(0 to 9), all, or blank
Incoming Calling Number Format
This field indicates the TON/NPI encoding applied to CPN information modified by the CLI
Prefix feature. This encoding does not apply to calls originating locally. The Numbering Format
field on page 2 of this screen applies to calls originated from this server running Communication
Manager.
If this field is blank, Avaya Communication Manager passes on the encoding received in the
incoming setup message. If the incoming setup message did not contain CPN information and
digits are added, the outgoing message will contain these digits. If the Format field is blank in
this case, the value defaults to pub-unk.
If the Format field on page 2 of this screen is also administered as unknown, the trunk group is
modified to unk-unk encoding of the TON/NPI. Therefore, this field also must contain a value
other than unknown.
Note:
The values for this field map to the Type of Numbering (TON) and Numbering
Note:
Plan Identifier (NPI) values shown below.
Usage
Enter a code to test signaling channel
Usage
Enter the number of digits to insert in the calling party number
for all incoming calls on this trunk group.
ISDN Trunk Group
Issue 2.1 May 2006 1197