Avaya Communication Manager Administrator's Manual page 1665

Tone (msec)
This field appears only if the Trunk Type field is blank. All CO, DIOD, and Tie circuit packs that
accept administrable timers accept this timer. This timer is also sent to the following circuit
packs: TN464B (or later), TN767, TN436B, TN459B, TN2146, TN2199, TN429, TN2184 ports in
a DID trunk group.
Valid entries
20 to 2550 in
increments of 10
OUTPULSING INFORMATION
Break (msec)
Valid entries
Enter the duration of the break interval (the pulse duration) while the system is outpulsing
digits using dial pulse signaling. The field cannot be blank.
20 to 80 in
increments of 5
10 to 40 in
increments of 5.
Frequency
This field identifies the PPM pulse frequency(ies) sent by the public network. It appears if the
Direction field is outgoing or two-way and PPM is y. Circuit packs can detect up to three
different frequencies, (12kHz, 16kHz, and 50Hz), plus two frequency combinations, (50Hz/
12kHz and 50Hz/16kHz). This field controls TN465B, TN2138, and TN2184 circuit packs.
Valid entries
12k
16k
Usage
Enter the duration of a DTMF tone sent when a button on a hybrid
telephone is pressed.
Usage
If PPS field is 10, the sum of the Make (msec) and Break (msec) fields
must equal 100.
If the PPS field is 20, the sum of the Make (msec) and Break (msec)
fields must equal 50.
Usage
The TN465B (or later) and TN2184 can only detect 12k and 16kHz PPM.
Therefore, if 12k is administered, the circuit pack will be set to detect 12kHz.
The TN465B (or later) and TN2184 can only detect 12k and 16kHz PPM.
Therefore, if 16k is administered, the circuit pack will be set to detect 16kHz.
Trunk Group
1 of 2
Issue 2.1 May 2006 1665