Avaya Communication Manager Administrator's Manual page 1651

Send Calling Number
Specifies whether the calling party's number is sent on outgoing or tandemed ISDN calls. Valid
entries are y, n, or r (restricted). If y is entered, the ISDN Numbering - Public/Unknown
Format screen is accessed to construct the actual number to be sent, or the ISDN Numbering
- Private screen (based on the Numbering Format field) is used. If the value is r, the calling
number is sent "presentation restricted.".
Note:
The ISDN Numbering - Public/Unknown Format screen can override the Send
Note:
Calling Number field entry for any administrable block of extensions.
Send Called/Busy/Connected Number
Appears if the QSIG Value-Added field on the Trunk Group screen is y. Specifies if the dialed
number, whether called (ringing), busy (busy tone), or connected (answered) is sent on
incoming or tandemed ISDN calls. Valid entries are y, n, or r (restricted). If y is entered, the
ISDN Numbering - Public/Unknown Format screen is accessed to construct the actual
number sent, or the ISDN Numbering - Private screen (based on the Numbering Format
field) is used. If the value is r, the connected number is sent "presentation restricted." The Send
Called/Busy/Connected Number field must be set to y in order for the Calling Party Number of
an incoming ISDN call to display at the transferred-to station after a QSIG transfer operation.
Send Connected Number
Appears if the QSIG Value-Added field on the Trunk Group screen is n. Specifies if the
connected party's number is sent on incoming or tandemed ISDN calls. Valid entries are y, n, or
r (restricted). If y is entered, the ISDN Numbering - Public/Unknown Format screen is
accessed to construct the actual number sent, or the ISDN Numbering - Private screen (based
on the Numbering Format field) is used. If the value is r, the connected number is sent
"presentation restricted." The Send Connected Number field must be set to y in order for the
Calling Party Number of an incoming ISDN call to display at the transferred-to station after a
QSIG transfer operation.
Note:
The AT&T Switched Network Protocol does not support restricted displays of
Note:
connected numbers. Therefore, if you administer the 1a country-protocol/
protocol-version combination on the DS1 screen, you should not administer the
Send Connected Number field to r (restricted) on the ISDN Trunk Group
screen, as this causes display problems.
The ISDN Numbering - Public/Unknown Format screen overrides the Send
Connected Number field entry for any administrable block of extensions.
Trunk Group
Issue 2.1 May 2006 1651