Avaya Communication Manager Administrator's Manual page 1655

If this field is y, you can administer ISDN-BRI trunk groups unless the DCS Signaling field is
d-chan. In that case, remove the BRI trunks or set the DCS Signaling field to bx.25 before
submitting the screen.
Field descriptions for Administrable Timers page
This screen might not appear for all trunk group types. The figure below is only an example, and
is intended to show most of the fields that might appear on this page of the Trunk Group
screen. This example might not show all fields, or might show fields that normally do not appear
together. Your own screen might vary from this example according to specific field and system
settings. The list of field descriptions that follows the figure is in alphabetical order for quick
reference. This list is intended to be comprehensive, and might include information on fields that
are not shown in the example. The field descriptions identify fields that are specific to particular
trunk group types.
Note:
This section does not cover ISDN trunks. For descriptions of the screens and
Note:
fields that are unique to ISDN trunks, see
Figure 590: Administrable Timers for Trunk Group screen
add trunk-group next
Incoming Glare Guard(msec): _____
Ringing Monitor(msec): _____
Outgoing End of Dial(sec): ___
Programmed Dial Pause(msec): _____
END TO END SIGNALING
Tone (msec): ____
OUTPULSING INFORMATION
PPS: 10
!
CAUTION:
Customers: Do not change fields on this page without assistance from Avaya or
CAUTION:
your network service provider.
ADMINISTRABLE TIMERS
Send Incoming/Outgoing Disconnect Timers to TN465 Ports? _
Flash Length(msec): ____
Pause (msec): 150
Make(msec): 40
ISDN Trunk Group
Outgoing Dial Guard(msec): _____
Outgoing Glare Guard(msec): _____
Outgoing Rotary Dial Interdigit (msec): ____
Incoming Seizure(msec): ____
Outgoing Seizure Response(sec): ___
Disconnect Signal Error(sec): ___
Busy Tone Disconnect?
Break(msec): 60 PPM? y
Trunk Group
on page 1195.
Page 3 of x
Frequency: 50/12k
Issue 2.1 May 2006 1655