System Parameters - Sccan - Avaya Communication Manager Administrator's Manual

System Parameters - SCCAN

Field descriptions for page 1
Figure 573: SCCAN-Related System Parameters screen
change system-parameters sccan
MM (WSM) Route Pattern
Enter a route pattern number that is SCCAN-enabled. Partition route pattern indexes, RHNPA
indexes, deny, or nodes are not allowed.
Valid entries
blank
digits
H1 Handover
Valid entries
unassigned
extension
SCCAN - RELATED SYSTEM PARAMETERS
MM(WSM) Route Pattern: ________
H1 Handover: ________
H2 Handover: ________
Announcement: ________
Special Digit Conversion? ________
Usage
Default value. If this field is left blank, the feature is turned off. To enable
this feature, you must enter an acceptable value. This is the default.
Right-click on the field on the SAT screen to see valid entries for your
system.
Usage
The primary handover number called to facilitate handover of a cellular
call to the WAN or WLAN. Depending on whether the user is entering or
exiting the Enterprise space, Communication Manager replaces the active
call with the new call made using the hand-off H1 or H2 number.
System Parameters - SCCAN
Issue 2.1 May 2006 1569