Avaya Communication Manager Administrator's Manual page 1151

IP Audio Hairpinning
Allows IP endpoints to be connected through the IP circuit pack in the server.
Valid entries
y/n
Location
Specifies the location of the IP network region, allowing correct date and time information, and
trunk routing based on IP network region.
Note:
If the Multinational Locations feature is enabled, and IP telephones derive their
Note:
network region from the IP Network Map, you must administer this field with a
valid value (1 to 250). This allows the IP endpoint to obtain a VoIP resource.
Valid entries
1 to 44
1 to 250
blank
RTCP Reporting Enabled
Valid entries
y/n
Usage
Enter y to allow IP endpoints to be connected through the media server's IP
circuit pack in IP format, without first going through the Avaya DEFINITY
TDM bus. Default is n.
Usage
(For CSI only.) Enter the number for the location for the IP network region.
The IP endpoint uses this as its location number. This applies to IP
telephones and softphones.
(For Avaya S8300/S8700 Media Servers) Enter the number for the
location for the IP network region. The IP endpoint uses this as its location
number. This applies to IP telephones and softphones.
The location is obtained from the cabinet containing the CLAN or the
media gateway that the endpoint registered with.
Usage
Enter y to send RTCP Reports to a special server, such as for the VMON
tool. If this field is set to y, then the RTCP Monitor Server Parameters
fields appear.
Note: Regardless of how this field is administered, RTCP packets are
always sent peer-to-peer.
IP Network Region
Issue 2.1 May 2006 1151