Avaya Communication Manager Administrator's Manual page 1319

Call Category for Vector ii-digits
Allows you to use the call category digit as the ii-digits on call vector steps.
Valid entries
y/n
Do Not Send Group B Signals to CO
This field appears only if the Incoming Call Type field is group-ii-mfc. This field allows
completion of a call without Group-B signals.
Valid entries
y
n
Number of Incoming ANI Digits
Valid entries
0 to 15
Number of Outgoing ANI Digits
This field applies to Russian shuttle trunks, and MFC and MFE trunks.
Valid entries
0 to 15
Usage
If y, the call category digit, which is a part of ANI, is used as the ii-digits on
call vector steps.
Usage
If y, does not send Group-B signals to complete an incoming call.
If n, sends Group-B signals to complete an incoming call.
Usage
Enter the number of ANI digits for incoming MFC calls.
Usage
Enter the number of ANI digits for outgoing MFC calls.
In India or any country where end-of-ani and end-of-digits are not defined
for Tones to CO on Outgoing Forward Calls - Group I, Avaya
Communication Manager appends ANI-Not-Available digits to ANI digits if
the actual ANI length is less than the number entered in this field.
If end-of-ani or end-of-digits are defined, this field is used in conjunction
with Truncate Station Number in ANI as a maximum ANI length.
For India, even if the length of ANI is defined, if the timeout occurs during
the ANI collection, the call is routed with the ANI digits already collected.
Multifrequency-Signaling-Related Parameters
Issue 2.1 May 2006 1319