Ip Interfaces - Avaya Communication Manager Administrator's Manual

IP Interfaces

Use the IP Interfaces screen to assign a network region to an IP interface device, or to
administer Ethernet options. The fields shown appear when the add, change, display, or
remove command is used.
Note:
For information about Processor Ethernet interfaces, see
Note:
Ethernet
The appearance of the IP Interfaces screen can vary according to the interface type you are
administering, and your system's configuration. The figures shown are examples, intended to
show most of the fields that might appear on this screen. Your own screen might vary from
these examples. The list of field descriptions that follows the figures is intended to be
comprehensive, and to include information on all fields that might appear. The field descriptions
are in alphabetical order for quick reference.
Note:
When you start the process of administering the IP interface for the TN2602AP
Note:
circuit pack, any active calls continue to use the TN2602AP circuit pack's
physical IP address for the connection, not the virtual IP address you are setting
in this procedure. Therefore, any of these calls, if they continue after you
complete this procedure, will drop in the event of an interchange.
on page 576.
IP Interfaces
Setting up Processor
Issue 2.1 May 2006 1137