Avaya Communication Manager Administrator's Manual page 1141

Enable Ethernet Pt
Allows use of the Ethernet port.
Valid entries
y/n
Gateway Address
Valid entries
0 to 255
Gatekeeper Priority
Appears only if Allow H.323 Endpoints is y and the Communication Manager server is a main
server or an LSP. This field does not display on an ESS server. This field allows a priority to be
set on the interface. This affects where the interface appears on the gatekeeper list.
Valid entries
1 to 9
Usage
Enter y to iindicate that the Ethernet port associated with the TN2602AP
circuit pack is in service. If this is an active board, set to n only when there
is no standby, or when the standby has been disabled.
Note: Enter n in this field before you make changes to the screen.
Usage
The IP address of the LAN gateway
This entry also applies to the second TN2602AP circuit pack when
Critical Reliable Bearer is y.
Note: The 4606, 4612, and 4624 telephones do not support the bearer
duplication feature of the TN2602AP circuit pack. If these telephones are
used while an interchange from active to standby media processor is in
process, calls might be dropped.
Usage
Enter the desired priority number. The value in this field is used on the
alternate gatekeeper list. The lower the number, the higher the priority.
Default is 5. For more information, see
(AGL) priorities on page 587.
associated with the TN2602AP.
Setting Alternate Gatekeeper List
Issue 2.1 May 2006
IP Interfaces
1141