Example usage:
To configure STP trap settings
DGS-1100-24P/ME:admin#config stp trap new_root enable
Command : config stp trap new_root enable
Success.
DGS-1100-24P/ME:admin#
config stp version
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To set STP version to RSTP
DGS-1100-24P/ME:admin#config stp version rstp
Command : config stp version rstp
Success.
DGS-1100-24P/ME:admin#
enable stp
Purpose
Syntax
Description
Parameters
Restrictions
DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
To set the STP version used by the switch.
config stp version [rstp | stp]
The config stp version command sets the STP version used by the
switch.
rstp – Rapid spanning tree protocol.
stp – Spanning tree protocol.
Only administrator-level users can issue this command.
To enable STP support of the switch.
enable stp
The enable stp command enables STP support of the switch.
Note: If Spanning Tree protocol is used, loopback detection will not
be available. If Loopback Detection is enabled, the Spanning Tree
protocol will not be available.
None.
Only administrator-level users can issue this command.
132