Rip Global Settings; Rip Interface Settings - D-Link DGS-3427 - xStack Switch - Stackable Product Manual

x Stack

RIP Global Settings

To setup RIP for the IP interfaces configured on the Switch, the user must first globally enable RIP and then configure RIP
settings for the individual IP interfaces.
To globally enable RIP on the Switch, click Administration > RIP > RIP > RIP Global Settings, as shown below.
To enable RIP, simply use the pull-down menu, select Enabled and click Apply.

RIP Interface Settings

RIP settings are configured for each IP interface on the Switch. This window appears in table form listing settings for IP interfaces
currently on the Switch. To configure RIP settings for an individual interface, click on the hyperlinked Interface Name.
To view this window, click Administration > RIP > RIP > RIP Interface Settings, as shown below.
Click the hyperlinked name of the interface to configure the settings for RIP, which will give access to the following window:
The following RIP interface settings can be applied to each IP interface:
Parameter Description
Interface Name The name of the IP interface on which RIP is to be setup. This interface must be previously
configured on the Switch.
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Figure 2 - 161 RIP Global Settings window
Figure 2 - 162 RIP Interface Settings window
Figure 2 - 163 RIP Interface Settings - Edit window
132