Logging Into The Cli; Creating A User Account; Configuring The Ip Address - D-Link DXS-3610 Series Hardware Installation Manual

DXS-3610 Series Layer 3 Stackable 10GbE Managed Switch Hardware Installation Guide

Logging into the CLI

At the login screen, enter the Username and Password and press Enter after each entry to access the CLI.
User Access Verification
Username:admin
Password:*****
Switch#
NOTE: For security reasons, it is highly recommended to configure a personal username and password
for this Switch.

Creating a User Account

To create a new user account, use the username command in the Global Configuration Mode.
Switch# configure terminal
Switch(config)# username NewUser password 12345
Switch(config)# username NewUser privilege 15
Switch(config)#
A user account with the username 'NewUser', password '12345', and privilege level 15 was created.
NOTE: Usernames can be up to 32 characters in length. Passwords can be up to 32 plain-text
characters in length. Passwords are case sensitive.

Configuring the IP Address

To configure the IP address of the Switch, use the ip address command in the VLAN Interface Configuration Mode.
Switch# configure terminal
Switch(config)# interface vlan 1
Switch(config-if)# ip address 10.50.50.50 255.0.0.0
Switch(config-if)#
The IP address of the Switch was change to '10.50.50.50' with the subnet mask of '255.0.0.0'.
DXS-3610-54S TenGigabit Ethernet Switch
Command Line Interface
Firmware: Build 1.00.028
Copyright(C) 2020 D-Link Corporation. All rights reserved.
23