Displaying Lldp Statistics And Configuration Settings; Lldp Configuration Summary - Dell PowerConnect B-RX Configuration Manual

9
Configuring LLDP
You can list all of the ports individually, use the keyword to to specify ranges of ports, or a
combination of both. To apply the configuration to all ports on the device, use the keyword all
instead of listing the ports individually. Note that using the keyword all may cause undesirable
effects on some ports. For example, if you configure all ports to advertise their VLAN name, and
the configuration includes ports that are not members of any VLAN, the system will warn of the
misconfigurations on non-member VLAN ports. The configuration will be applied to all ports,
however, the ports that are not members of any VLAN will not send VLAN name advertisements.

Displaying LLDP statistics and configuration settings

You can use the following CLI show commands to display information about LLDP settings and
statistics:
•
•
•
•
•
This above show commands are described in this section.

LLDP configuration summary

To display a summary of the LLDP configuration settings on the device, enter the show lldp
command at any level of the CLI.
The following shows an example report.
FastIron#show lldp
LLDP transmit interval
LLDP transmit hold multiplier
LLDP transmit delay
LLDP SNMP notification interval
LLDP reinitialize delay
LLDP maximum neighbors
LLDP maximum neighbors per port
Syntax: show lldp
The following table describes the information displayed by the show lldp statistics command.
This field...
LLDP transmit interval
LLDP transmit hold
multiplier
LLDP transmit delay
272
show lldp – Displays a summary of the LLDP configuration settings.
show lldp statistics – Displays LLDP global and per-port statistics.
show lldp neighbors – Displays a list of the current LLDP neighbors.
show lldp neighbors detail – Displays the details of the latest advertisements received from
LLDP neighbors.
show lldp local-info – Displays the details of the LLDP advertisements that will be transmitted
on each port.
Displays...
The number of seconds between regular LLDP packet transmissions.
The multiplier used to compute the actual time-to-live (TTL) value of an LLDP
advertisement. The TTL value is the transmit interval multiplied by the transmit hold
multiplier.
The number of seconds the LLDP agent will wait after transmitting an LLDP frame and
before transmitting another LLDP frame.
: 10 seconds
: 4 (transmit TTL: 40 seconds)
: 1 seconds
: 5 seconds
: 1 seconds
: 392
: 4
BigIron RX Series Configuration Guide
53-1001986-01