Set Console Transfer Ppp - Lucent Technologies Cajun P550 Cli Reference Manual

Console
      ...

 
  
   
Transfers control of the serial console port and the CLI session to the PPP protocol layer.
This command is only accepted when the console serial port is configured in PPP mode.
When accepted, this command immediately terminates the current CLI session, logs the user out,
and switches the I/O on the serial console port from the CLI processing software to the PPP layer.
The remote host also needs to simultaneously change its I/O to use PPP software. This command is
NOT stored (no back-end), and is only for use when the user has successfully dialed-into the
Cajun. This command can only be accepted when the Console Serial Port is configured in PPP
mode.
The command cannot be accepted from a telnet session, it can only be accepted over
directly connected serial sessions, and most preferably from a post-dial modem terminal
session on the remote host.

 
 
Cajun(configure)# set console transfer ppp
5-8
To Enable:

set console transfer ppp

Cajun P550/P220 Command Line Interface Reference Guide