STAP
.
.
Sets the bridge priority for a particular bridge. The default priority is 0 x 8000 (in hexidecimal).
Command Syntax
To Enable:
Name
priority-value
802.1D
vlan-id
vlan-name
This example sets the spanning tree priority for the 802.1D Legacy Bridge.
Cajun(configure)# set spantree priority 0xAAAA vlan 1
Bridge Priority Successfully set to 0xAAAA
15-16
set spantree priority <priority-value> {802.1D|vlan
{<vlan-id>|name <vlan-name }}
Table 15-11. Parameters, Keywords, Arguments
Definition
The bridge priority, specified as a two byte value in
hexidecimal (0x8000).
Configure the IEEE 802.1D Legacy Bridge.
Note: The 802.1D bridge can only be
Configure a per-vlan or dual-layer bridge by using
the VLAN's vlan ID.
Note: LAN bridges can only be modified
Configure a per-vlan or dual-layer bridge by using
the VLAN's name.
Note: VLAN bridges can only be modified
modified when in the IEEE config
mode.
when in per-vlan or dual-layer mode.
when in per-vlan or dual-layer mode.
Cajun P550/P220 Command Line Interface Reference Guide