Area Virtual-Link - Lucent Technologies Cajun P550 Cli Reference Manual

OSPF
 *

   " '
   
To define an OSPF virtual link, use the area virtual-link router configuration command
with the optional parameters. To remove a virtual link, use the no form of this
command.

  
To Enable:
To Disable:
Name
area-id
router-id
hello-interval <seconds>
10-10
area <area-id> virtual-link <router-id> [hello-interval
<seconds>] [retransmit-interval <seconds>]
[dead-interval <seconds>] [{authentication-key <key> |
message-digest-key <key-id> md5 <key>}]
[no] area <area-id> virtual-link <router-id>
[hello-interval <seconds>] [retransmit-interval
<seconds>] [dead-interval <seconds>]
[{authentication-key <key> | message-digest-key <key-id>
md5 <key>}]
Table 10-8. Parameters, Keywords, Arguments
Definition
IP address that represents the area-id for the system.
Router ID associated with the virtual link neighbor.
The router ID appears in the show ip ospf display. It
is internally derived by each router from the router's
interface IP addresses. This value must be entered in
the format of an IP address. There is no default.
Time in seconds between the hello packets that the
Cisco IOS software sends on an interface. Unsigned
integer value to be advertised in the software's hello
packets. The value must be the same for all routers
and access servers attached to a common network.
The default is 10 seconds.
Cajun P550/P220 Command Line Interface Reference Guide