Set Spantree Port - Lucent Technologies Cajun P550 Cli Reference Manual

STAP
 .  .

 
  
   
Enables or disables spanning tree on a bridge port. The default state is enabled.
Command Syntax
To Enable:
Name
mod-port-range
enable|disable
802.1D
vlan-id
vlan-name
15-8
set spantree port <mod-port-range> [... [,]
<mod-port-range>] {enable | disable} {802.1D | vlan
{<vlan-id> | name <vlan-name> }}
Table 15-7. Parameters, Keywords, Arguments
Definition
Specifies a particular port or a range of ports on a
module.
Enable or disable spanning tree for the bridge port.
Configure the IEEE 802.1D Legacy Bridge.
Note: The 802.1D bridge can only be
Configure a per-vlan or dual-layer bridge by using
the VLAN's vlan ID.
Note: LAN bridges can only be modified
Configure a per-vlan or dual-layer bridge by using
the VLAN's name.
Note: VLAN bridges can only be modified
modified when in the IEEE config
mode.
when in per-vlan or dual-layer mode.
when in per-vlan or dual-layer mode.
Cajun P550/P220 Command Line Interface Reference Guide