Set Spantree Port-Top-Change-Detection - Lucent Technologies Cajun P550 Cli Reference Manual

STAP
 .  .*.*  *

 
  
   
Enable or disable the topology port change detection ability of a bridge port. The default
state is enabled.
Command Syntax
To Enable:
Name
mod-port-range
enable|disable
802.1D
vlan-id
vlan-name
15-10
set spantree port-top-change-detection <mod-port-range>
[... [,] <mod-port-range>]] {enable | disable} {802.1D |
vlan {<vlan-id> | name <vlan-name>}}
Table 15-8. Parameters, Keywords, Arguments
Definition
Specifies the module and the port range.
Enable or disable topology change detection for the bridge
port.
Configure the IEEE 802.1D Legacy Bridge.
Note: The 802.1D bridge can only be
Configure a per-vlan or dual-layer bridge by using
the VLAN's vlan ID.
Note: LAN bridges can only be modified
Configure a per-vlan or dual-layer bridge by using
the VLAN's name.
Note: VLAN bridges can only be modified
modified when in the IEEE config
mode.
when in per-vlan or dual-layer mode.
when in per-vlan or dual-layer mode.
Cajun P550/P220 Command Line Interface Reference Guide