Set Spantree Config - Lucent Technologies Cajun P550 Cli Reference Manual

STAP
 .   

 
  
   
Set the current spanning tree configuration. The default setting is per-VLAN.

 
To Enable:
Name
ieee
per-vlan
dual-layer
disable
 
This example sets the spanning tree configuration to ieee.
Cajun(configure)# set spantree config ieee
Config successfully set to ieee
15-4
set spantree config {ieee|per-vlan|dual-layer|disable}
Table 15-3. Parameters, Keywords, Arguments
Definition
The entire switch is a single IEEE 802.1D-compliant
bridge.
Each VLAN functions as a separate IEEE
802.1D-compliant bridge. VLAN bridges can only be
displayed when in per-vlan or dual-layer mode.
A proprietary version of per-VLAN, where the vlan
id is embedded as a tag within the bridge PDUs.
Disables spanning tree on the switch.
Cajun P550/P220 Command Line Interface Reference Guide