Ldap Producer-Signal - Lucent Technologies Cajun P550 Cli Reference Manual

. .* 

    "
   
Set the producer signal. The producer signal default is 0 and can either be set directly, or
by preceding this command with no.

 
To Enable:
To Disable:
Name
producer-signal
System Supported: P550R
Cajun P550/P220 Command Line Interface Reference Guide
ldap producer-signal <producer-signal>
[no] ldap producer-signal <producer-signal>
Table 6-1. Parameters, Keywords, Arguments
Definition
Triggers the LDAP client to download the latest
config. If the download is successful the consumer
signal is set to this producer signal. If there was a
problem with the access list the consumer signal
shows -1.
Setting the producer signal to 0 will have the effect
of preventing the LDAP client from comparing this
producer signal value with that downloaded from
the server. This is an additional check that is done to
safeguard against downloading a bad policy.
If the producer signal is nonzero and the compare
fails, the policy does not go into effect and the
consumer signal is set to -1.
If the producer signal is nonzero and the compare
succeeds, the policy goes into effect and the
consumer signal matches this producer signal value.
If the LDAP client can not even download the ACLs,
the consumer signal remains unchanged.
LDAP
6-3