.. *
Create an appletalk static route. The no form of this command removes the static route
itself, or only removes a zone from the static route if the zone name is supplied.
To Enable:
To Disable:
Name
cable-range
network.node
Cajun P550/P220 Command Line Interface Reference Guide
appletalk static cable-range <cable-range> to
<network.node> [floating] zone <zone-name>
[no] appletalk static cable-range <cable-range> to
<network.node>
Table 3-8. Parameters, Keywords, Arguments
Definition
The range of Appletalk network values to be used for
this static route. Specify start and end values, in
decimal, between 0 and 65279 and separate the
values with a hyphen.
The starting network number must be less than the
ending network number. The next hop appletalk
router is specified via the network.node parameter.
Specifies the Appletalk Network Address of the next
hop to the destination network. (Both numbers are
in decimal.)
• network - A 16-bit network number between 0
and 66279.
• node - An 8-bit node number between 0 and
254.
Appletalk
3-13