Ip Ospf Router-Id - Lucent Technologies Cajun P550 Cli Reference Manual

OSPF
. *
.

    
   
To set the router-id for the system, use the ip ospf router-id command. Use the no form
of this command, to Revert to the system default (the lowest IP address configured on
the system).
Note: OSPF must be disabled for this command to take effect. If OSPF is enable on
the system the change will not take effect until OSPF is stopped and started
again.
Command Syntax
To Enable:
To Disable:
Name
router-id
10-26
ip ospf router-id <router-id>
[no] ip ospf router-id <router-id>
Table 10-19. Parameters, Keywords, Arguments
Definition
IP address that represents the router-id for the
system.
Cajun P550/P220 Command Line Interface Reference Guide