Set Spantree Portcost - Lucent Technologies Cajun P550 Cli Reference Manual

STAP
 .  .

 
  
   
Sets the path cost of a particular bridge port. The defaults are: 100 for a 10MB port, 19 for a 100
MB port, and 4 for a 1 GB port.
Command Syntax
To Enable:
Name
mod-port-range
cost-value
802.1D
vlan-id
vlan-name
15-12
set spantree portcost <mod-port-range> [...[,]
<mod-port-range>] <cost-value> {802.1D|vlan {<vlan-id>|
name <vlan-name>}}
Table 15-9. Parameters, Keywords, Arguments
Definition
Specifies the module and the port range.
The path cost for the bridge port.
Configure the IEEE 802.1D Legacy Bridge.
Note: The 802.1D bridge can only be
Configure a per-vlan or dual-layer bridge by using
the VLAN's vlan ID.
Note: LAN bridges can only be modified
Configure a per-vlan or dual-layer bridge by using
the VLAN's name.
Note: VLAN bridges can only be modified
modified when in the IEEE config
mode.
when in per-vlan or dual-layer mode.
when in per-vlan or dual-layer mode.
Cajun P550/P220 Command Line Interface Reference Guide