Displaying The Method Of Probing For Proprietary Features; Showing Virtual Port Information; Listing The Link Configuration Information For All Virtual Ports - Lucent Technologies CAJUN M770 User Manual

Displaying the method of probing for proprietary features

To display the method of probing for a virtual port, use the
Command:
Output:
Parameter:

Showing Virtual Port Information

Listing the link configuration information for all virtual ports

You can view the link configuration information for all virtual ports or for a specific
virtual port.
Any virtual port information that is marked with an asterisk (*) has been learned
by the M770 ATM Switch during the ILMI dialogue with the remote device.
Information that is not marked with an asterisk has either been configured by the
user or is the default setting for the virtual port.
To view the link configuration information about all virtual ports, enter the
vport show config
Command:
Parameter:
Example:
Output:
Cajun M770 ATM Switch User's Guide
M15-155s8:/>vport probe <vport id>
Method of probing for proprietary features: MIB
<vport id>
command.
M15-155s8:/>vport show config [<vport id>]
The virtual port. This is displayed in the format
<vport id>
<slot>.<port>.<virtual port number>.
If a <virtual port number> parameter is not supplied then
the link configuration summary information is displayed
for all virtual ports.
M15-155s8:/>vport show config
Virtual Port Configuration Information
Virtual Admin Oper ILMI
Port Id State State Enabled Mode
8.0.0 Up Up No
8.1.0 Down Down Yes
8.2.0 Up Up Yes
8.3.0 Up Down Yes
8.4.0 Down Down Yes
Chapter 6
vport probe
The virtual port in the form
<slot>.<port>.<virtual port number>.
Poll Multi Strict Sig. SSCOP
Reg AAL
Disabled On Off
None On Off
Port + ESI On Off
None On Off
None On Off
Managing Virtual Ports
command.
Wait for
Rx. Window Peer SSCOP
Default No
Default No
Default No
Default No
Default No
69