Emerson R&S SGT100A User Manual page 458

®
R&S SGT100A
Example:
[:SOURce<hw>]:BBIN:MPERiod <MPeriod>
Sets the recording duration for measuring the baseband input signal by Auto Level Set.
Parameters:
<MPeriod>
Example:
Manual operation:
[:SOURce<hw>]:BBIN:OFFSet:I <I>
[:SOURce<hw>]:BBIN:OFFSet:Q <Q>
This command enters a DC offset to the I / Q component of the external baseband sig-
nal.
Parameters:
<Q>
Example:
[:SOURce<hw>]:BBIN:OLOad:HOLD:RESet
This command executes a reset of the Overload Hold State and LED.
User Manual 1176.8674.02 ─ 12
DIGItal
The external digital baseband signal is fed into the signal path
via the "Digital Input" connector. The internal signal processing
is based on a sample rate of 100 MHz. Input signals with a sam-
ple rate less than 100 MHz are upsampled. The sample rate can
be estimated or defined by the user in the appropriate entry
fields.
*RST: ANALog
BBIN:SOUR ANAL
selects an external analog signal as the input signal. The signal
must be applied at the inputs I and Q.
integer
Range: 1 to 32
*RST: 2
Default unit: s
BBIN:MPER 4s
sets the recording duration for Auto Level Set to 4 seconds.
See "Measurement Period"
float
Range: -10 to 10
Increment: 0.001
*RST: 0
Default unit: %FS
BBIN:OFFS:Q -0.1PCT
sets -0.1 %FS DC offset to the Q component of the external
input signal.
Remote control commands
SOURce subsystem
on page 267
458