Emerson R&S SGT100A User Manual page 249

®
R&S SGT100A
Sensor type and serial number
The side tab label indicates type and serial number of an R&S NRP power sensor and
its mapping index.
The
Remote command:
:SENSe<ch>[:POWer]:TYPE?
:SENSe<ch>[:POWer]:SNUMber?
Level (Peak) / Level (Average)
Indicates the measured peak or average level value.
You can also change the unit for the results display: Watt, dBm or dBμV.
Note: Peak level measurements are provided if the power sensor supports this feature.
Remote command:
:READ<ch>[:POWer]?
:SENSe<ch>:UNIT[:POWer]
Sensor Mapping
Accesses the
Sensor
Indicates the connector the sensor is connected to.
Sensor Settings
One tab per sensor provides the corresponding setting parameters.
State ← Sensor Settings
Enables level measurement of the R&S NRP power sensor.
Remote command:
:INITiate<hw>[:POWer]:CONTinuous
To query the availability of a sensor at a given connector, use the command
SENSe<ch>[:POWer]:STATus[:DEVice]?
Zero ← Sensor Settings
Activates the auto zeroing.
For details, see
Remote command:
:SENSe<ch>[:POWer]:ZERO
Display ← Sensor Settings
Sets the display mode for power readings.
User Manual 1176.8674.02 ─ 12
└ Aperture Time............................................................................................... 252
└ S-Parameter..................................................................................................252
└ Enable Logging............................................................................................. 252
Level (Peak) / Level (Average)
on page 381
NRP sensor mapping
"About zeroing"
values display the current readings of the sensor.
on page 389
on page 387
on page 381
dialog.
on page 380
on page 388.
on page 246.
on page 389
Signal generator settings
RF settings
:
249