Multi-Segment Waveform Sequencing; Segment Restart - Emerson R&S SGT100A User Manual

®
R&S SGT100A
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:MARKer:FSEGment
on page 442

Segment Restart

Enables/disables the generation of an additional marker restart signal in the output
waveform file.
If additional marker generation is enabled, the existing marker signals in the individual
segment waveform files are not considered.
"Disable"
"Marker
1/2/3/4"
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:MARKer:ESEGment
on page 442

Multi-segment waveform sequencing

The settings provided in the "Multi Segment Waveform Sequencing" dialog can be
adjusted to crate a "play list", i.e. to define the sequence in which the waveform file
segments are processed and how many times each of them is repeated. The config-
ured play list is displayed in form of a "Sequencing Graphic".
All segments in a "play list" must have the same clock rate.
In the "ARB" main dialog or in the "ARB Trigger/Marker/Clock" dialog, set the "Next
Segment Mode" to "Sequencer" to activate the configured "play list".
Sequencing List
Displays the name of the selected sequencing list file, i.e. the file with the "play list" set-
tings.
The sequencing list file has an extension *.wvs and is automatically assigned to but
independent from the multi-segment file. By default, both files have the same name
and are located in the same file directory. More than one sequencing list files can be
created per multi-segment waveform file.
The sequencing list file carries information only about the segment number. The corre-
sponding waveform file names are retrieved from the assigned multi-segment wave-
form file. I.e., the same sequencing list file can be reused for different multi-segment
waveform files with the same number of segments.
Changes and recalculations of a multi-segment waveform file cause a recheck whether
the assigned sequencing list files are still valid. A message is displayed to inform about
necessary corrections in the "play list".
Remote command:
n.a.
User Manual 1176.8674.02 ─ 12
No additional marker is generated.
Generates a restart marker signal at the beginning of each segment
for the corresponding marker.
The starting point of the segment is set at the low-high slope of the
marker. The setting applies for switching between two segments and
for replaying segments.
Signal generator settings
Baseband
102