Sconfiguration Subsystem - Emerson R&S SGT100A User Manual

®
R&S SGT100A
Manual operation:
:OUTPut[:STATe] <State>
Activates the RF output signal ([RF on/off]).
Parameters:
<State>
Manual operation:
:OUTPut[:STATe]:PON <Pon>
Selects the state of the RF output when the instrument is switched on.
Parameters:
<Pon>
Manual operation:

10.12 SCONfiguration subsystem

:SCONfiguration:MODE
:SCONfiguration:MODE <Configuration>
Switches between standard mode and ARB mode for envelope tracking.
Parameters:
<Configuration>
User Manual 1176.8674.02 ─ 12
AUTO
The attenuator is switched automatically. The level settings are
made in the full range.
APASsive
The attenuator is switched automatically. The level settings are
made only for the passive reference circuits. The high-level
ranges are not available.
FIXed
The level settings are made without switching the attenuator.
When this operating mode is switched on, the attenuator is fixed
to its current position and the resulting variation range is defined.
*RST: AUTO
See "Mode" on page 227
1 | ON | 0 | OFF
See "RF On/Off" on page 68
OFF | UNCHanged
OFF
Deactivates the output when the instrument is switched on ([RF
off]).
UNCHanged
Restores the initial state of the RF output before the last turn off.
*RST: UNCHanged
See "Power-On State"
.................................................................................................. 374
STANdard | AFETracking
Remote control commands
SCONfiguration subsystem
on page 229
374