Selftest - Emerson R&S SGT100A User Manual

®
R&S SGT100A
Access:
► Select "SGMA-GUI > Instrument Name > Setup > Diagnostic / Test".
The selection provides the following settings.
Settings:
●

Selftest.................................................................................................................. 296

● Connector
● Keyboard
● Power servoing
● Simulation............................................................................................................. 299
7.14.1 Selftest
Access:
► Select "SGMA-GUI" > "<Instrument name>" > "Diagnostic / Test" > "Self Test".
To run a selftest
1. Select "SGMA-GUI" > "<Instrument name>" > "Diagnostic / Test" > "Self Test".
2. To trigger a selftest execution, select "Start Selftest".
Performs a self test on all installed hardware options.
The result of the selftest, succeeded or failed, is displayed. The list of the numeric
results of the performed test cases is protected by protection level 2.
User Manual 1176.8674.02 ─ 12
General instrument settings and instrument setup
test.......................................................................................................297
tests...................................................................................................... 297
test...............................................................................................298
Diagnostic and tests
296