Emerson R&S SGT100A User Manual page 105

®
R&S SGT100A
Creating a multi-carrier waveform file
1. Configure general settings.
2. Configure carrier table.
3. Enter filename of the multi-carrier waveform ("Output File").
4. Save and load the multi-carrier waveform ("Create" or "Create and Load").
Accessing the multi-carrier settings
To access the "Multi Carrier" dialog, select "Baseband > ARB >General > Multi Car-
rier...".
The menu can be used to create a multi-carrier waveform and save it under its own
name. As with normal waveforms, the file extension is *.wv. Information on clock rate,
number of samples and creation day is displayed in the file menu when a waveform is
loaded.
Default settings and state
The upper part of the "General"dialog is used for calling the default settings and saving
and recalling existing ARB multi carrier submenu settings.
Set to Default
Calls default settings. The values are shown in the following table.
User Manual 1176.8674.02 ─ 12
Signal generator settings
Baseband
105