Arm; Execute Trigger; Trigger Source; Sync. Output To External Trigger - Emerson R&S SGT100A User Manual

®
R&S SGT100A

Arm

Available only in the "Running mode" and for "Trigger Mode > Armed_Auto" or "Trigger
Mode > Armed_Retrigger".
Stops the waveform output.
Signal output can be restarted by a new trigger (internally with "Execute Trigger" or
externally).
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TRIGger:ARM:EXECute

Execute Trigger

Executes the trigger manually. A manual trigger can be executed only when an internal
trigger source and a trigger mode other than "Auto" have been selected.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TRIGger:EXECute

Trigger Source

Selects trigger source.
"Internal"
"External"
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TRIGger:SOURce

Sync. Output to External Trigger

Available only for "Trigger Source > External".
Enables/disables output of the signal synchronous to the external trigger event.
"On"
User Manual 1176.8674.02 ─ 12
The trigger event is executed by "Execute Trigger".
The trigger event is executed with the aid of the active edge of an
external trigger signal.
The trigger signal is supplied via the [USER 1/2] connector.
The polarity, the trigger threshold and the input impedance of the trig-
ger input can be set in the "Connector" dialog.
Corresponds to the default state of this parameter.
The signal calculation starts simultaneously with the external trigger
event but because of the instrument's processing time that the first
samples are cut off and no signal is outputted. After the internal pro-
cessing time elapses, the output signal is synchronous to the trigger
event.
Signal generator settings
Baseband
on page 406
on page 406
on page 409
123