Emerson R&S SGT100A User Manual page 454

®
R&S SGT100A
The value of the signal bandwidth should not be higher than the channel spacing
SOURce<hw>]:BB:ARBitrary:CFR:CSPacing).
Parameters:
<ArbCfrSignalBw>
Manual operation:
[:SOURce<hw>]:BB:ARBitrary:CFR:SFReq <ArbCfrStopBFreq>
Sets the stopband frequency of the filter, if
FILTer
quency are filtered out by the lowpass filter.
Parameters:
<ArbCfrStopBFreq>
Example:
Manual operation:
[:SOURce<hw>]:BB:ARBitrary:CFR:TBANdwidth <DDArbCfrTranBw>
Sets the transition bandwidth of the cancellation pulse for peak cancellation CFR algo-
rithm.
Parameters:
<DDArbCfrTranBw> float
Example:
Manual operation:
[:SOURce<hw>]:BB:ARBitrary:CFR:WAVeform:CREate <CreateWvFile>
With enabled signal generation, triggers the instrument to save the current settings in a
waveform file. Waveform files can be further processed.
The filename and the directory it is saved in are user-definable; the predefined file
extension for waveform files is *.wv.
User Manual 1176.8674.02 ─ 12
float
Range:
Increment: 0.1
*RST:
See "Signal Bandwidth"
is set to ENHanced. Frequency components higher than the stopband fre-
float
Range:
Increment: 0.1
*RST:
See Example"Applying clipping and filtering algorithm"
on page 449.
See "Stopband Frequency"
Range:
Increment: 0.1
See Example"Applying peak cancellation algorithm"
on page 449.
See "Transition Bandwidth"
Remote control commands
0 to depends on the sample rate of the loaded file
250E6
on page 140
[:SOURce<hw>]:BB:ARBitrary:CFR:
0 to depends on the sample rate of the loaded file
250E6
on page 140
0 to 250E6
on page 141
SOURce subsystem
([:
454