Considerations For Test Setup - Emerson R&S SGT100A User Manual

®
R&S SGT100A
Left
Middle = Stacked correctly, different dimensions
Right = Stacked incorrectly, too many products
3. NOTICE! Overheating can damage the product.
Prevent overheating as follows:
●
●
3.1.4.2 Mounting the R&S SGT in a rack
To prepare the rack
1. Observe the requirements and instructions in
2. NOTICE! Insufficient airflow can cause overheating and damage the product.
Design and implement an efficient ventilation concept for the rack.
To mount the R&S SGT in a rack
1. Use an adapter kit that fits the dimensions of the R&S SGT to prepare the instru-
ment for rack mounting.
a) Order the rack adapter kit designed for the R&S SGT. For the order number,
b) Mount the adapter kit. Follow the assembly instructions provided with the
2. Push the R&S SGT onto the shelf until the rack brackets fit closely to the rack.
3. Tighten all screws at the rack brackets with a tightening torque of 1.2 Nm to secure
the R&S SGT in the rack.
To unmount the R&S SGT from a rack
1. Loosen the screws at the rack brackets.
2. Remove the R&S SGT from the rack.
3. If placing the R&S SGT on a bench top again, unmount the adapter kit from the
R&S SGT. Follow the instructions provided with the adapter kit.

3.1.5 Considerations for test setup

Cable selection and electromagnetic interference (EMI)
Electromagnetic interference (EMI) can affect the measurement results.
User Manual 1176.8674.02 ─ 12
= Stacked correctly, same dimensions
Keep a minimum distance of 10 cm between the fan openings of the product
and any object in the vicinity.
Do not place the product next to heat-generating equipment such as radiators
or other products.
see data sheet.
adapter kit.
Getting started
Preparing for use
"Setting up the product" on page 12.
20