Clock Subsystem - Emerson R&S SGT100A User Manual

®
R&S SGT100A
:CALibration:ROSCillator:DATA:MODE <Mode>
Defines whether the factory provided or a custom defined calibration value is used to
adjust the reference oscillator.
Parameters:
<Mode>
Example:
Manual operation:
:CALibration:ROSCillator[:DATA] <Data>
Sets the calibration value for the custom defined external adjustment.
Parameters:
<Data>
Manual operation:

10.5 CLOCk subsystem

:CLOCk:INPut:FREQuency?
:CLOCk:INPut:SLOPe
:CLOCk:OUTPut:MODE
:CLOCk:SYNC[:STATe]?
:CLOCk:INPut:FREQuency?
Queries the measured frequency of the external clock signal. An external clock refer-
ence must be supplied at the [USER1/2] input.
Return values:
<Frequency>
Example:
Usage:
Manual operation:
User Manual 1176.8674.02 ─ 12
FACTory | CUSTomer
*RST: FACTory
:CALibration1:ROSCillator:DATA:MODE CUSTomer
:CALibration1:ROSCillator:DATA 35600
See "Active Adjustment Data"
integer
Range: 0 to INT_MAX
*RST: 0
See "Calibration Value"
........................................................................................... 357
.................................................................................................... 358
..................................................................................................358
................................................................................................. 358
float
Range: 0 to max
Increment: 0.001
*RST: 0
CLOC:INP:FREQ?
queries the measured frequency of the external clock reference.
Query only
See "Measured External Clock"
Remote control commands
CLOCk subsystem
on page 301
on page 301
on page 134
357