Emerson R&S SGT100A User Manual page 414

®
R&S SGT100A
Parameters:
<Divider>
Manual operation:
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:PULSe:FREQuency?
The command queries the pulse frequency of the pulsed marker signal in the setting
SOURce:BB:ARB:TRIGger:OUTPut:MODE PULSe. The pulse frequency is derived
by dividing the symbol rate by the divider. The divider is defined with com-
mand :BB:ARB:TRIG:OUTP:PULS:DIV.
Return values:
<Frequency>
Example:
Usage:
Manual operation:
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut:DELay:FIXed <Fixed>
The command restricts the marker delay setting range to the dynamic range. In this
range the delay can be set without restarting the marker and signal. If a delay is
entered in setting ON but is outside this range, the maximum possible delay is set and
an error message is output.
The setting always affects every marker.
Parameters:
<Fixed>
Example:
Manual operation:
User Manual 1176.8674.02 ─ 12
integer
Range: 2 to 1024
*RST: 2
See "Marker Mode" on page 131
float
Increment: 0.001
BB:ARB:TRIG:OUTP2:PULS:DIV 4
sets the divider for the marker signal on the output to the value
4.
BB:ARB:TRIG:OUTP2:MODE PULS
enables the pulsed marker signal.
BB:ARB:TRIG:OUTP2:PULS:FREQ?
queries the pulse frequency of the marker signal.
Response: 33 000
the resulting pulse frequency is 33 kHz.
Query only
See "Marker Mode" on page 131
0 | 1 | OFF | ON
*RST: 0
BB:ARB:TRIG:OUTP:DEL:FIX ON
restricts the marker signal delay setting range to the dynamic
range.
See "Fix marker delay to current range"
Remote control commands
SOURce subsystem
on page 133
414