Emerson R&S SGT100A User Manual page 30

®
R&S SGT100A
The R&S SGT uses the Zeroconf IP addresses 169.254.xxx.yyy, where xxx takes val-
ues from 1 to 254 and yyy the values from 1 to 255. The subnet mask is always
255.255.0.0. The IP address of the host must be within the same address area for Zer-
oconf.
Assigning a static IP address to the R&S SGT
Prerequisites: A connection is established between the R&S SGT and the controller
with installed SGMA-GUI.
For how to set up a LAN connection, see
For how to set up a USB connection, see
the R&S SGT"
1. Open "SGMA-GUI > Instrument > Setup > Network Settings" dialog.
2. Set the "Address Mode" to "Static".
3. Enter the "IP Address", for example 192.168.0.1..
4. Enter the "Subnet mask", for example 255.255.255.0.
5. Enter the "Default Gateway", for example 192.168.0.1.
Assigning a static IP address to your Windows-PC network card
1. Obtain the IP address and subnet mask for the R&S SGT and the IP address for
the local default gateway from your network administrator. If necessary, also obtain
the name of your DNS domain and the IP addresses of the DNS and WINS servers
on your network. If you use more than one LAN connector, you need separate
address information for each connector.
2. Press the "Windows" key to access the operating system.
3. Open the "Control Panel" by selecting "Start > Settings > Control Panel".
4. Select "Network and Sharing Center".
5. In the left panel, click "Change adapter settings".
6. Select the network adapter that you want to change. Click "Change settings of this
connection".
7. On the "Networking" tab, click "Internet Protocol Version 4 (TCP/IPv4)". Select
"Properties".
8. Select "Use the following IP address".
9. Enter the address information as obtained from the network administrator.
10. If necessary, you can also select "Use the following DNS server addresses" and
enter your own DNS addresses.
For more information, refer to your Windows system help.
User Manual 1176.8674.02 ─ 12
on page 32.
"Connecting to the network"
"Setting up a USB connection from a PC to
Getting started
Preparing for use
on page 29.
30