Connecting The Controller And The Instrument - Emerson R&S SGT100A User Manual

®
R&S SGT100A
●
The following table list the available commands.
If you enter an additional optional command, SgtDriverDemo executes it and
enters a loop waiting for further commands.
Example:
TCPIP::10.111.11.44::5025::SOCKET ?
Lists the available commands.

9.3.4 Connecting the controller and the instrument

The "PCIe" connector is located on the
Permitted PCIe cables
PCIe extension cables must fulfill the following requirements:
●
Single lane connectors
●
Maximum cable length of 5 m.
For example: OSS-PCIe-CBL-x1 cable from One Stop Systems or 74576-000x cable
from Molex.
Connecting an external PC that does not support hot-plugging
1. Switch off the external PC and the instrument.
See also
2. NOTICE! Risk of device failure. The R&S SGT is equipped with a single lane PCIe
interface that supports hot plugging.
Do not connect an external PC to the PCIe connector of the instrument during
operation if this external PC does not support hot-plugging.
Connect the instrument and the controller with a permitted PCIe cable as specified
in
User Manual 1176.8674.02 ─ 12
cmd is an optional command (see table).
Command
?
q
f value
f?
l value
l?
rvalue
r?
Chapter 3.1.10, "Switching on or
"Permitted PCIe cables"
Network operation and remote control
Advanced remote control using PCIe
Description
Usage
Quit
Set frequency
Query frequency
Set level
Query level
Set RF state (value = 0 | 1 | ON | OFF)
Query RF state
rear panel.
off",
on page 326.
on page 24.
326