Preset Commands; Calibration Subsystem - Emerson R&S SGT100A User Manual

®
R&S SGT100A

10.3 Preset commands

The preset commands are not bundled into one subsystem. Therefore, they are listed
separately in this section. These specific commands are described in the associated
subsystems.
The following presetting actions are available:
●
Activating the default state of all internal instrument functions
Functions that concern the integration of the instrument into a measurement setup
are not changed, e.g. TCP/IP address or reference oscillator source settings.
●
Activating the original state of delivery (factory
on page 354). Only functions that are protected by a password remain unchanged
and the passwords themselves.
:SOURce<hw>:PRESet
:SYSTem:PRESet
Triggers an instrument reset. It has the same effect as:
●
The *RST command
●
The "SGMA-GUI > Instrument Name > Preset" function.
However, the command does not close open GUI dialogs like the function does.
Example:
Usage:
:SYSTem:FPReset
Triggers an instrument reset to the original state of delivery.
Example:
Usage:
Manual operation:

10.4 CALibration subsystem

:CALibration<hw>:BBIN[:MEASure]?
:CALibration:ALL[:MEASure]?
:CALibration:FREQuency[:MEASure]?
:CALibration:IQModulator:BBANd[:STATe]
:CALibration:IQModulator:FULL?
:CALibration:IQModulator:LOCal?
:CALibration:IQModulator:IQModulator[:STATe]
User Manual 1176.8674.02 ─ 12
SYST:PRES
All instrument settings (also the settings that are not currently
active) are reset to their default values.
Setting only
SYST:FPR
all instrument settings (also those that are not currently active)
are reset to the factory values.
Event
See "Execute Factory Preset"
................................................................................355
......................................................................................... 355
..............................................................................355
........................................................................ 355
..................................................................................... 356
....................................................................................356
................................................................. 356
Remote control commands
CALibration subsystem
(*RST on page 351).
reset,:SYSTem:FPReset
on page 295
354