®
R&S
SGT100A
5. Select "ARB > State > On".
The R&S SGT processes the waveform file.
8.6 How to restore the LAN connection
If you lose the LAN connection of the instrument, for example, after assigning a static
IP address, proceed as follows:
► On the front panel of the instrument, press the [LAN] LED for more than 3 seconds.
Pressing trigger a reset of the LAN settings. In particular, the
on page 288 switches to "DHCP".
If your network supports automatic assignment of IP address, the new IP address
is assigned to the instrument automatically.
8.7 How to switch between operating states
The
trigger the switch-over between them.
Figure 8-1: Operating states
"Setup" > "Standby", "Setup" > "Restart","Shut Down
Instruments and Exit"
[POWER ON/STANDBY], power switch [I/0]
The
User Manual 1176.8674.02 ─ 12
Figure 8-1
gives an overview of the operating states of the instruments and how to
Table 8-2
provides a short description of the operating states and their indication.
Performing configuration tasks
How to switch between operating states
"Address Mode"
= R&S SGMA-GUI controls
= Hardkey controls on the front/rear panel of the
instrument
306