Emerson R&S SGT100A User Manual page 396

®
R&S SGT100A
Manual operation:
[:SOURce<hw>]:AWGN:MODE <Mode>
Selects the mode for generating the interfering signal.
Parameters:
<Mode>
Example:
Manual operation:
[:SOURce<hw>]:AWGN:POWer:CARRier <Carrier>
available for Additive Noise and CW Interferer (SOUR:AWGN:MODE ADD|CW) modes
Sets/queries the carrier or signal power depending on the selected reference mode.
●
SOUR:AWGN:POW:RMOD CARR
Sets the carrier power. The power of the noise signal is derived from the entered
C/N value.
●
SOUR:AWGN:POW:RMOD NOIS
queries the carrier power which is derived from the entered C/N value. The noise
power is set with command SOUR:AWGN:POW:NOISe.
Parameters:
<Carrier>
Example:
Manual operation:
User Manual 1176.8674.02 ─ 12
See "Target CW Frequency Offset"
ONLY | ADD | CW
ADD
The AWGN noise signal is added to the baseband signal.
ONLY
The pure AWGN noise signal is modulated to the carrier. The
connection to the baseband is interrupted.
CW
The sine interfering signal is added to the baseband signal.
*RST: ADD
SOURce:AWGN:MODE ONLY
SOURce:AWGN:STATe ON
selects the generation of a pure noise and activates it
See "Mode" on page 144
float
Increment: 0.01
*RST: 0
Default unit: dBm
AWGN:POW:CARR?
queries the carrier power
See "Carrier Power / Signal Power"
Remote control commands
SOURce subsystem
on page 145
on page 148
396