Front Panel Tour - Emerson R&S SGT100A User Manual

®
R&S SGT100A
The meanings of the labels on the R&S SGT are described in
R&S

3.2.1 Front panel tour

This section provides an overview of control elements on the front panel of the
R&S SGT. The front panel contains LEDs to inform you about the status of the instru-
ment, in particular for remote control of the R&S SGT.
The connectors of the R&S SGT are on the
Figure 3-3: R&S SGT front panel controls
1 = [POWER ON/STANDBY]
2 = [RF ON]
3 = [REF EXT]
4 = [ERROR / WARNING]
5 = [LAN]
6 = [ID]
[POWER ON/STANDBY]
The [POWER ON/STANDBY] key switches the instrument from the standby to the
ready state or vice versa.
The LED above the [POWER ON/STANDBY] key indicates the instrument state, see
Table
How to:
●
Chapter 3.1.10, "Switching on or
●
"To switch between standby and ready state"
[RF ON]
The [RF ON] key switches the RF signal on or off. If activated, the key is green.
Table 3-4: Overview of RF signal states
[RF ON] state
On
Off
How to:
[REF EXT]
The [REF EXT] key activates synchronization to an external reference signal.
User Manual 1176.8674.02 ─ 12
SGT", on page 13.
1 2 3 4
3-2.
LED
green
gray
Chapter 3.1.8, "Connecting to RF
rear panel.
5 6
off", on page 24
on page 25
Remark
RF signal output at the RF 50Ω connector.
No RF signal output.
50Ω", on page 22
Getting started
Instrument tour
Chapter 1.2, "Labels on
33