Emerson R&S SGT100A User Manual page 450

®
R&S SGT100A
[:SOURce<hw>]:BB:ARBitrary:CFR[:STATe]
[:SOURce<hw>]:BB:ARBitrary:CFR:ALGorithm
[:SOURce<hw>]:BB:ARBitrary:CFR:CPBandwidth
[:SOURce<hw>]:BB:ARBitrary:CFR:CSPacing
[:SOURce<hw>]:BB:ARBitrary:CFR:DCFDelta
[:SOURce<hw>]:BB:ARBitrary:CFR:FILTer
[:SOURce<hw>]:BB:ARBitrary:CFR:FORDer
[:SOURce<hw>]:BB:ARBitrary:CFR:ITERations
[:SOURce<hw>]:BB:ARBitrary:CFR:MEASure[:STATe]?
[:SOURce<hw>]:BB:ARBitrary:CFR:OCFactor?
[:SOURce<hw>]:BB:ARBitrary:CFR:PFReq
[:SOURce<hw>]:BB:ARBitrary:CFR:RCFactor?
[:SOURce<hw>]:BB:ARBitrary:CFR:SBANdwidth
[:SOURce<hw>]:BB:ARBitrary:CFR:SFReq
[:SOURce<hw>]:BB:ARBitrary:CFR:TBANdwidth
[:SOURce<hw>]:BB:ARBitrary:CFR:WAVeform:CREate
[:SOURce<hw>]:BB:ARBitrary:CFR[:STATe] <ArbCfrState>
Enables the crest factor reduction calculation.
Parameters:
<ArbCfrState>
Manual operation:
[:SOURce<hw>]:BB:ARBitrary:CFR:ALGorithm <ArbCfrAlgorithm>
Defines the algorithm for crest factor reduction.
Parameters:
<ArbCfrAlgorithm>
Example:
Example:
User Manual 1176.8674.02 ─ 12
..................................................................... 450
................................................................. 450
.................................................................. 451
.................................................................. 451
....................................................................... 451
.................................................................... 452
................................................................ 452
.................................................................452
...................................................................... 453
.................................................................453
.............................................................. 453
...................................................................... 454
.............................................................. 454
1 | ON | 0 | OFF
*RST: 0
See "State" on page 138
CLFiltering | PCANcellation
CLFiltering
Clipping and filtering algorithm. This algorithm performs a hard
clipping of the baseband signal. It is followed by a low pass filter-
ing of the result in an iterative manner until the target crest factor
is reached. You can define the settings of the filter that is used
for the calculation.
PCANcellation
Peak cancelation algorithm. This algorithm subtracts Blackman
windowed sinc pulses from the signal wherever the amplitude is
above a defined threshold.
*RST: CLFiltering
See Example"Applying clipping and filtering algorithm"
on page 449.
See Example"Applying peak cancellation algorithm"
on page 449.
Remote control commands
SOURce subsystem
.............................................................451
.....................................................452
..................................................... 454
450