Emerson R&S SGT100A User Manual page 238

®
R&S SGT100A
The "Execute" button is only enabled if a sensor is detected and the user correction list
contains at least one frequency value.
Remote command:
[:SOURce<hw>]:CORRection:ZERoing:STATe
[:SOURce<hw>]:CORRection:CSET:DATA[:SENSor<ch>][:POWer]:SONCe
on page 472
Used Instrument Settings For Measurement
Displays the settings relevant for the measurement.
"Modulation"
"Amplitude"
"Use SParameter"
"Attenuator Mode"
"Fixed range (PEP) In"
Remote command:
n.a.
6.7.6.8 Power servoing
Access:
► Select "SGMA-GUI > Instrument Name > RF > Level > Power Servoing".
The tab provides settings to configure power servoing.
User Manual 1176.8674.02 ─ 12
Indicates the modulation state
Shows the currently set level.
Indicates whether SParameter correction is used.
Displays the selected mode of the attenuator.
Shows the level range.
Signal generator settings
RF settings
on page 477
238