Emerson R&S SGT100A User Manual page 460

®
R&S SGT100A
Parameters:
<Delay>
[:SOURce<hw>]:BBIN:PGAin <PGain>
This command enters the relative gain for the external baseband signal compared with
the signals of the other baseband sources. The actual gain of the different baseband
signals depends not only on the path gain setting but also on the signal characteristics
such as the crest factor and on the number of used sources. used and on the total RF
output power. The gain affects the signal on the "Baseband" In block output.
Parameters:
<PGain>
Example:
[:SOURce<hw>]:BBIN:POWer:PEAK <Peak>
This command enters the peak level of the external baseband signal relative to full
scale of 0.5 V (in terms of dB full scale).
Parameters:
<Peak>
Example:
Manual operation:
[:SOURce<hw>]:BBIN:POWer:RMS?
This command queries the rms level of the external digital baseband signal.
Return values:
<Rms>
User Manual 1176.8674.02 ─ 12
float
Range: 0 to 1
Increment: 1E-9
*RST: 0
float
Range: -50 to 50
Increment: 1E-3
*RST: 0
Default unit: dB
BBIN:PGA 3dB
sets the relative gain of 3 dB for the external baseband signal.
float
Range: -60 to 3.02
Increment: 0.01
*RST: 0
Default unit: dBfs
BBIN:POW:PEAK -2
enters the peak level of -2 dBfs.
See "Peak Level" on page 267
float
Range: -100 to 10
Increment: 0.01
*RST: 0
Remote control commands
SOURce subsystem
460