Operation Mode; Frequency / Phase - Emerson R&S SGT100A User Manual

®
R&S SGT100A
RF On/Off
Activates and deactivates the RF output signal.
The current state of the RF output (activated and deactivated) is indicated in the main
panel by the different block color (blue or grey) and the status "On/Off".
Remote command:
:OUTPut[:STATe]

6.7.2 Operation mode

You can operate the R&S SGT in two modes, normal mode and baseband bypass
mode. In baseband bypass mode, an external IF signal fed in at the [I] or [Q] connec-
tors is directly routed to the [RF OUT] connector. The level of the signal can be adjus-
ted.
► To access the "Operation Mode" dialog, select "SGMA-GUI > Instrument Name >
RF > Operation Mode".
Operation Mode
Sets the operation mode.
"Normal"
"Baseband Bypass"
Remote command:
[:SOURce]:OPMode

6.7.3 Frequency / phase

The frequency and phase-related settings are provided in the "Frequency/Phase" dia-
log.
► To access this dialog, select "SGMA-GUI > Instrument Name > RF > Frequency/
Phase".
User Manual 1176.8674.02 ─ 12
on page 374
The complete signal processing chain is used.
The IF signal fed in at the "I" or "Q" connectors is directly routed to
the "RF OUT" connector.
on page 391
Signal generator settings
RF settings
217