Emerson R&S SGT100A User Manual page 307

®
R&S SGT100A
Table 8-2: Indication of the operating states
Operating
state
Off
Booting
Standby
Ready
(normal
operation)
To switch the instrument to standby state
► Use one of the following:
a) On the remote PC, select "SGMA-GUI > Instrument Name > Setup > Standby".
b) Press the [POWER ON/STANDBY] key on the front panel of the instrument.
c) Send the SCPI command:
The current instruments settings are automatically saved. The instrument switches
to a power-saving mode.
In the R&S SGMA-GUI, the standby state is indicated by the red state symbol in
front of the corresponding instrument's name, on the front panel, by the orange
[POWER ON/STANDBY] button.
To return the instrument from standby to ready state
► Use one of the following:
a) On the remote PC, select "SGMA-GUI > Instrument Name > Setup > Restart".
b) Press the orange [POWER ON/STANDBY] key on the front panel of the instru-
The instrument loads the last setup with all instrument settings, switches to ready
state and is ready for normal operation.
In the R&S SGMA-GUI, the ready state is indicated by the green state symbol in
front of the instrument's name.
On the front panel, the ready state is indicated by the green [POWER ON/
STANDBY] button.
User Manual 1176.8674.02 ─ 12
Description
The instrument is shut down.
The instrument boots the operating system
and starts the instrument firmware.
If the previous session was terminated reg-
ularly, the instrument uses the last setup
with the relevant instrument settings.
In this state, it is safe to switch off the AC
power and disconnect the instrument from
the power supply.
The remote control system is not active.
The instrument is ready for operation. All
modules are power-supplied.
:SYSTem:REBoot
ment.
Performing configuration tasks
How to switch between operating states
Indication
All LEDs on the front panel of the instrument
are off.
The green [POWER ON/STANDBY] key blinks.
In the R&S SGMA-GUI, the status indicator in
front of the instrument name is red.
The orange [POWER ON/STANDBY] key is
on.
In the R&S SGMA-GUI, the status indicator in
front of the instrument name is green.
The green [POWER ON/STANDBY] key is on.
307