Next Segment; Next Segment Mode - Emerson R&S SGT100A User Manual

®
R&S SGT100A

Next Segment

Selects the waveform segment to be output next. It determines the start segment when
switching on the ARB and enables switchover to any other segment.
The switchover is performed either after receiving an external next segment trigger
event or, for the internal trigger case, by changing the segment index in the "Next Seg-
ment" field. The definition whether the new segment is generated immediately or only
after the previous segment has been fully generated (wrap around) is determined by
the parameter
The segment currently being output (segment index and filename) is displayed at "Cur-
rent Segment". The subsequent trigger event after the last segment causes the first
segment to be output again.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:NEXT

Next Segment Mode

Sets the segmented trigger mode of a multi-segment waveform, i.e. defines the switch
over between segments in a multi-segment waveform:
●
In "Same Segment" mode, the processing of the multi-segment waveform file is
similar to the processing of a non-multi-segment waveform, i.e. there is no switch-
ing to consecutive segments, when receiving a trigger event.
Switching between the segments is triggered by changing the segment index in the
"Next Segment" field.
●
When "Next Segment" is selected, the current segment ceases to be output when
a trigger event for a new segment occurs, and the new segment starts to be output
after a system-imposed signal gap.
The following figure shows an example of the transition from a sine-wave signal
segment to a sawtooth segment (I channel, above) for next segment external trig-
gering (below).
●
When "Next Segment" seamless is selected and a new segment trigger event
occurs, the new segment is not output until the whole of the current segment has
User Manual 1176.8674.02 ─ 12
Next Segment Mode.
Signal generator settings
Baseband
on page 446
126