Rf Settings; Overview Of Rf Signal - Emerson R&S SGT100A User Manual

®
R&S SGT100A
Remote command:
[:SOURce<hw>]:IQ:DPD:SHAPing:NORMalized:DATA:CATalog?
[:SOURce<hw>]:IQ:DPD:SHAPing:NORMalized:DATA:LOAD
[:SOURce<hw>]:IQ:DPD:SHAPing:NORMalized:DATA:STORe
Pin
Max
Sets the value of the maximum input power level.
Pin
max
the x-axis.
Select "Apply" to confirm the settings.
Remote command:
n.a.
Vin/Vmax, Delta V/V, Delta Phase (deg)
Sets the correction as a group of three values.
Select "Apply" to confirm the settings.
Remote command:
See
Apply, OK
Triggers the instrument to adopt the normalized data.
Use "OK" to apply the setting and exits the dialog.
Remote command:
[:SOURce<hw>]:IQ:DPD:SHAPing:NORMalized:DATA

6.7 RF settings

6.7.1 Overview of RF signal

Settings for the RF output signal and analog modulation are made under "RF Signal"
and "Analog Modulations". These settings can be accessed in the block diagram by the
"RF" function block, or by the dialog with the same name which is opened through
"SGMA-GUI > Instrument Name > RF".
The function block is available for the basic unit R&S SGT without any additional
equipment options.
User Manual 1176.8674.02 ─ 12
corresponds to a normalized input power of 1, that is the max. allowed value on
"Apply, OK" on page 216.
Signal generator settings
RF settings
on page 514
on page 514
on page 514
on page 513
216