Emerson R&S SGT100A User Manual page 519

®
R&S SGT100A
[:SOURce<hw>]:PULM:STATe <State>
Activates the pulse modulation.
Parameters:
<State>
Example:
Manual operation:
[:SOURce<hw>]:PULM:TRIGger:EXTernal:GATE:POLarity <Polarity>
Selects the polarity of the Gate signal.
Parameters:
<Polarity>
Example:
Manual operation:
[:SOURce<hw>]:PULM:TRIGger:EXTernal:IMPedance <Impedance>
Selects the impedance for external pulse trigger.
Parameters:
<Impedance>
Example:
Manual operation:
[:SOURce<hw>]:PULM:TRIGger:EXTernal:SLOPe <Slope>
Parameters:
<Slope>
Example:
Manual operation:
User Manual 1176.8674.02 ─ 12
0 | 1 | OFF | ON
*RST: 0
PULM:STAT ON
activates pulse modulation.
See "State" on page 257
NORMal | INVerted
*RST: NORMal
PULM:TRIG:EXT:GATE:POL NORM
The pulse signal is generated while the gate signal is high.
See "Gate Input Polarity"
G50 | G10K
*RST: G50
SOUR:PULM:TRIG:EXT:IMP G50
selects 50 Ohm as the trigger impedance for the external pulse
trigger.
See "External Impedance"
NEGative | POSitive
*RST: POSitive
PULM:TRIG:EXT:SLOP NEG
The pulse generator is triggered on the negative slope of the
external trigger signal.
See "Ext. Trigger Input Slope"
Remote control commands
SOURce subsystem
on page 260
on page 257
on page 260
519