Emerson R&S SGT100A User Manual page 528

®
R&S SGT100A
[:SOURce]:ROSCillator:OUTPut:FREQuency <OutputFreq>
Selects the output for the reference oscillator signal.
Parameters:
<OutputFreq>
Manual operation:
[:SOURce]:ROSCillator:EXTernal:SBANdwidth <SBandwidth>
Sets the synchronization bandwidth for an external reference signal.
Parameters:
<SBandwidth>
Example:
Manual operation:
[:SOURce]:ROSCillator[:INTernal]:ADJust[:STATe] <State>
Determines whether the calibrated (OFF) or a user-defined (ON) adjustment value is
used for fine adjustment of the frequency.
If user-defined values are used, the instrument is no longer in the calibrated state.
However, the calibration value is not changed and the instrument resumes the calibra-
ted state after sending the com-
mand :SOURce:ROSCillator:INTernal:ADJust:STATe OFF.
Parameters:
<State>
Example:
User Manual 1176.8674.02 ─ 12
10MHZ | 100MHZ | 1000MHZ | 13MHZ
13MHZ requires RF board with part number 1419.5308.02.
See "Output Frequency"
WIDE | NARRow
NARRow
The synchronization bandwidth is.
WIDE
Synchronization bandwidth is.
*RST: n.a. (factory preset)
ROSC:SOUR EXT
Selects the external source.
ROSC:EXT:FREQ 10 MHz
Informs the instrument that the external reference has a fre-
quency of 10 MHz.
ROSC:EXT:SBAN WID
Selects wideband setting for synchronization bandwidth.
See "Synchronization Bandwidth"
0 | 1 | OFF | ON
*RST: n.a. (factory preset: 0)
ROSC:SOUR INT
Selects the internal source.
ROSC:ADJ ON
Activates use of a user-defined adjustment value.
ROSC:ADJ:VAL 1400
Sets the adjustment value to 1400.
Remote control commands
SOURce subsystem
on page 222
on page 222
528